Changes

added heatsink drill/tap drawing link
Line 507: Line 507:  
* 1pcs 8mm tall, 7mm OD, 3.6mm ID black nylon unthreaded standoffs (unmodified)
 
* 1pcs 8mm tall, 7mm OD, 3.6mm ID black nylon unthreaded standoffs (unmodified)
 
* 2pcs above standoff, modified to have a 2.5mm - 2.63mm tall flange, with the rest of the cylinder cut away to have a 2.6mm deep [https://en.wikipedia.org/wiki/Sagitta_(geometry) sagitta]
 
* 2pcs above standoff, modified to have a 2.5mm - 2.63mm tall flange, with the rest of the cylinder cut away to have a 2.6mm deep [https://en.wikipedia.org/wiki/Sagitta_(geometry) sagitta]
 +
 +
[https://github.com/rene-dev/stmbl/blob/master/hw/kicad/v4.0/doc/heatsink.pdf stmbl/heatsink.pdf at master · rene-dev/stmbl] (shows drill/tap hole pattern for mounting HV board to heatsink)
    
=== Case ===
 
=== Case ===