Mesa Electronics

From CNC Wiki
Revision as of 00:24, 5 September 2019 by Fdarling (talk | contribs) (added mesaflash commands)
Jump to navigation Jump to search

Overview

Mesa Electronics is a company that sells LinuxCNC compatible FPGA cards/boards and expansion boards.

Connectivity

Their cards are traditionally PCI or PCI-Express interfaced, but there are also Ethernet connected cards. The Ethernet solution is often more convenient for several reasons:

  1. remote location
  2. electrical isolation
  3. requires only a free Ethernet port on the host

Firmware

For the ethernet based boards, the firmware can be flashed over the network using the mesaflash utility. You must know which board it is, and the IP address of the board. The board can usually have jumpers set to have a fixed known IP, so as long as you manually configure the ethernet interface of the host to be within the same subnet as the card, you should be able to ping it.

For example, the default IP is usually 192.168.1.121:

ping 192.168.1.121

And you can read the current configuration of the card using the following command:

mesaflash --device 7i92 --addr 192.168.1.121 --readhmid

To flash a new bitfile, issue this command:

mesaflash --device 7i92 --addr 192.168.1.121 --write 7i92_7i77x2.bit

The board must be power cycled after flashing for the new firmware/settings to take effect.

Ethernet Boards

25-pin boards

50-pin boards

PCI Boards

25-pin boards

50-pin boards

PCI-Express Boards

25-pin boards

50-pin boards

Parallel Port Boards

25-pin boards

50-pin boards

Online Resources

http://www.mesanet.com/

http://store.mesanet.com/