STMBL v4 Servo Drives: Difference between revisions
added snap rivet information |
added heatsink drill/tap drawing link |
||
| Line 507: | Line 507: | ||
* 1pcs 8mm tall, 7mm OD, 3.6mm ID black nylon unthreaded standoffs (unmodified) | * 1pcs 8mm tall, 7mm OD, 3.6mm ID black nylon unthreaded standoffs (unmodified) | ||
* 2pcs above standoff, modified to have a 2.5mm - 2.63mm tall flange, with the rest of the cylinder cut away to have a 2.6mm deep [https://en.wikipedia.org/wiki/Sagitta_(geometry) sagitta] | * 2pcs above standoff, modified to have a 2.5mm - 2.63mm tall flange, with the rest of the cylinder cut away to have a 2.6mm deep [https://en.wikipedia.org/wiki/Sagitta_(geometry) sagitta] | ||
[https://github.com/rene-dev/stmbl/blob/master/hw/kicad/v4.0/doc/heatsink.pdf stmbl/heatsink.pdf at master · rene-dev/stmbl] (shows drill/tap hole pattern for mounting HV board to heatsink) | |||
=== Case === | === Case === | ||