CNC Wiki

STMBL v4 Servo Drives: Difference between revisions

← Older editNewer edit →
corrected Mesa Smart Serial pinout
added Mesa card grounding note
Line 24: Line 24:
| style="background: repeating-linear-gradient(45deg, #ff8000, #ff8000 10px, #ffffff 10px, #ffffff 20px);" | orange-stripe  
| style="background: repeating-linear-gradient(45deg, #ff8000, #ff8000 10px, #ffffff 10px, #ffffff 20px);" | orange-stripe  
| STEP+
| STEP+
| RX+
| RX-
|-
|-
| 2
| 2
| style="background-color: #ff8000" | orange
| style="background-color: #ff8000" | orange
| STEP-
| STEP-
| RX-
| RX+
|-
|-
| 3
| 3
Line 39: Line 39:
| style="background-color: #0080ff" | blue
| style="background-color: #0080ff" | blue
| FAULT-
| FAULT-
| VCC
| GND
|-
|-
| 5
| 5
| style="background: repeating-linear-gradient(45deg, #0080ff, #0080ff 10px, #ffffff 10px, #ffffff 20px);" | blue-stripe
| style="background: repeating-linear-gradient(45deg, #0080ff, #0080ff 10px, #ffffff 10px, #ffffff 20px);" | blue-stripe
| FAULT+
| FAULT+
| VCC
| GND
|-
|-
| 6
| 6
Line 54: Line 54:
| style="background: repeating-linear-gradient(45deg, #8b4513, #8b4513 10px, #ffffff 10px, #ffffff 20px);" | brown-stripe
| style="background: repeating-linear-gradient(45deg, #8b4513, #8b4513 10px, #ffffff 10px, #ffffff 20px);" | brown-stripe
| EN+
| EN+
| GND
| VCC
|-
|-
| 8
| 8
| style="background-color: #8b4513" | brown
| style="background-color: #8b4513" | brown
| EN-
| EN-
| GND
| VCC
|}
|}


NOTE: the above Mesa Smart Serial (Mesa SS) RJ45 wiring is for the STMBL side, the pinout is not directly mapped/compatible with Mesa's convention! This also means that you can only follow the wire color / pin # convention of either the Mesa or the STMBL, not both. The following is the pinout expected by the Mesa card:
NOTE: the STMBL drives do not actually use the VCC/GND connections, they just end up driving differential transceivers (with non-differential signals). The STMBL expects to have a common logic ground with the Mesa card.


Mesa Smart Serial RJ45 Pinout:
Mesa Smart Serial RJ45 Pinout:
Retrieved from "https://www.cncwiki.org/index.php?title=STMBL_v4_Servo_Drives"