JST JGD-125C Water Cooled Spindle: Difference between revisions

← Older edit Newer edit →

@@ Line 55: / Line 55: @@
 === O-rings ===
-Must fit within a 10mm OD 1mm deep recess with a 6mm ID hole for water to pass through. Maybe one of these?:
+The top cap with the water inlets have 10mm OD 1mm deep recesses with a 6mm ID hole for O-rings. Maybe one of these?:
 * [https://www.mcmaster.com/1171N144/ Square-Profile Oil-Resistant Buna-N O-Ring, 1.5 mm Wide, 7 mm ID | McMaster-Carr]
@@ Line 63: / Line 63: @@
 * [https://www.mcmaster.com/1302N037/ Oil-Resistant Buna-N O-Ring, 1.8 mm Wide, 6 mm ID | McMaster-Carr]
 * [https://www.mcmaster.com/9262K166/ Oil-Resistant Buna-N O-Ring, 2 mm Wide, 6 mm ID | McMaster-Carr]
+The bearing housing portion of the spindle has 8mm OD 1mm? deep recesses with 4mm? ID holes for O-rings.
 === Fasteners ===